Buildon Bondit Plaster BOND+ is high-performance bonding agent for gypsum and sand cement….
BUILDON Gypsum Plaster 1 Coat is produced from the light powder-density rock sourced from the purest mines. The advantage of our Gypsum is that it is the highest grade, pure white in colour, and 40% harder than any other Gypsum Plaster available in the Indian market. This Gypsum plaster can be applied easily and directly on all surfaces without the need for sand/cement/ plaster on the walls. The coverage in a 25Kg bag is 20 Sq. Ft. with a thickness of 12mm. The Fineness of 250 Mesh and purity over 90% ensure the best atomic bond and an absolute mirror finish.
Approved by
Applied on
Brick Wall
Block Wall
RCC Structure
Application of Gypsum
The surface must be clean, dry, firm & free of dust.
Important properties like soluble salt content, thermal characteristics, shrinkage, strength, suction bonding properties etc of the background which is to plastered, should be evaluated before application.
Gypsum plaster one coat can be applied directly on most surfaces like Brick walls/Fly ash brick/Siporex blocks/Concrete surfaces/Sand cement plaster walls etc.
A suitable fixture can be fixed after the plaster has been set. You can put up fixtures of varying weights. Smaller ones can be supported by using steel hooks and pins, while heavier frames and objects can be accommodated with plugs and screws or suitable fixtures, adequately penetrated into the background to ensure a firm hold.
Tools for Application
Mixing Bucket
Plumb BOB
Steel Trowel
Right Angled Scale
Line Dori
Aluminium Channel
Measuring Tape
Mixing Bucket
Plumb BOB
Steel Trowel
Right Angled Scale
Line Dori
Aluminium Channel
Measuring Tape
Direction For Use
The right way to mix is to add the powder to water, not water to the powder.
The ratio of the powder should be 1:1.30.
Avoid mixing more powder that can be used within 12 minutes - 15 minutes.
Do not temper or mix fresh material
once a mix has started to set.
After taking the required amount of plaster, always fold the open end,
to protect the plaster from moisture.
The setting time cannot be altered by diluting the mixture. For a longer setting time, the BUILDON retarder should be added.
Features
Single coat application
Very smooth finish
Can be applied directly on all walls/surfaces
Free of shrinkage cracks
Zero maintenance
Compatible with all types of paints
Pure white in colour
Technical Specifications
Purity
90% and above
Whiteness
92%
Fineness Mesh
Mesh 200,
Residue 2%
Setting Time
Intial 12 - 15 min.
Final 24 - 30 min.
Compressive Strength (Dry)
20 N/mm2
Coverage at 12mm thickness
20 Sq. ft.
Dry Bulk Density
750 Kg / m3
Standard Compliance
IS 2547-1 Part 1 & Part 2
Shelf Life
8 months
Application Process
Apply a thick layer on brick wall
Apply a thin layer on board
Apply directly on surface
Level it out with an aluminium channel or straight edge. Leave until partially set.
Steel Trowel is used to scrape dead plaster off the wall
Clean all tools
Apply a thick layer on brick wall
Apply a thin layer on board
Apply directly on surface
Level it out with an aluminium channel or straight edge. Leave until partially set.
Steel Trowel is used to scrape dead plaster off the wall
Clean all tools
More Products
Explore products that will meet your needs,
BONDIT-151 is high performance bonding agent for Gypsum on concrete blocks/RCC surfaces.
Buildon P-20 is a Premixed sand cement plaster. It is specially formulated for exterior and interior plastering work to …